Categories
Gear Luggage

Luggage Release Loop on a Brompton

The luggage block on a Brompton, like so much on the bicycle, is sheer genius.  It places the weight of front luggage on the frame, which means that there’s no destabilization when turning, even when carrying substantial weight.

lp1

But it can be a little inconvenient to reach under a bag to pull the release lever.  Fortunately, the lever has a channel running through it — it’s that little circle on the lever, below the block, modelled above by Argyll.

lp2

I added a cord loop to the release on Basil’s luggage block.  It loops around his stem, stays completely out of the way, and makes it much easier for me to release a bag.

lp3

The cord is run through from opposite sides, and knotted on each side.  In a belt-and-suspenders move, I also stitched the loose ends to the loop.

Viola!  Pull the loop and release the bag; no fumbling under the luggage required.  This might not be a big deal for many people, but my runty little arms really appreciate the more convenient reach.  It’s speedier, too.

ll-sv

I saw this nifty fix when I followed a link from a bikeforums.net discussion of Brompton luggage.  Poster trrubicon06 made a far more elegant one (using actual hardware; his Brompton may be an older one without the channel in the release lever).  Check it out here:  trrubicon06’s Brompton luggage release.

Categories
Gear

This was a happy discovery . . .

Basil’s home-made bottle holder accommodates a paper coffee cup:

cf-hd

I ran out of hands while picking up drinks for two recently.  Basil to the rescue!

The bottle holder is made from a stroller/pushchair accessory, details here.

Categories
Miscellaneous

Shirk’s Bike Shop

Almost in the middle of nowhere — well, actually in East Earl, Pennsylvania — is an amazing bike shop.  Located in the rolling hills of Lancaster County, Pennsylvania, Shirk’s is in an area populated by Mennonite and Amish families.  It’s not uncommon here to see horse-drawn buggies, and men, women, and children getting around on bicycles and scooters, as modern conveniences are shunned by many members of these groups.

 

shr-sg
I’d gone past Shirk’s when participating in a couple of cycling events.  Shirk’s is closed on Sunday, not surprisingly, but water in coolers and snacks were left out for cyclists who were passing by during those events.  I’d wondered about a bike shop that would provide refreshment to cyclists during hours when it wasn’t even open.

A couple of months ago I saw a woman wearing a fluorescent helmet with the features I wanted, and asked where she’d gotten it.  “Shirk’s” she said, and that was the impetus I needed to finally check the shop out.  Also, Lancaster County is beautiful, and the drive through it, particularly when it’s not tourist season, can be very rewarding.

shr-tlIt turns out that Shirk’s has the stock density of an old-time urban hardware store, but without the space limitations.  Looking for bike tools?  Shirk’s has everything from the basics to all kinds of very modern mcro-multi-tools.

shr-t2Want a quality saddle?  Shirk’s carries Brooks, Bontrager, Selle Anatomica, Terry, and more — and a full selection of women’s and smaller sizes, too.shr-sdThere’s plenty of spandex for men, women, and children, along with baskets, grips, cell phone mounts and all kinds of bike accessories. And bikes themselves.  Lots and lots of bikes; it’s an entire warehouse, in fact.

shr-fbk

No Bromptons, though; if you live in East Earl, your need for a folding bike is probably minimal.  If your buggy breaks down, presumably you ride the horse home.  (If your horse gets into trouble, presumably that’s a whole different issue.)

shr-b2Old school approaches haven’t kept Shirk’s from adapting:  There are shelves of gels, bars, energy drinks and more.

shr-wt

Including a wall of helmets, which I failed to photograph because I was busy buying one.  The fellow who helped me expertly fitted mine, so I went home without dreading doing the sizing ineptly myself.

shr-shp

I also picked up a multi-tool, the women’s florescent, short-fingered cycling gloves I can’t find anywhere else, and another sunscreen skull cap for under my helmet.  A day’s work well done!

Shirk’s is a good distance from major population centers, but oh, what a drive!

shrvl

That’s the view from the store’s parking lot, looking left, above.  Below is the view looking to the right.

shrvr

Befitting its Mennonite origin, the store has no website; Shirk’s is one huge Internet secret. But when noodling around online for the address and directions, I did come across a great article about Shirk’s in Bicycling Magazine.  It’s very much worth a read.

The store’s address, which, happily, was included in the article, is:

Shirk’s Bike Shop
1649 Ligalaw Rd.
East Earl, PA 17519

Phone:  717/445-5731

There’s a large, active, repair shop on the premises; truing wheels is a speciality.  It’s kind of a dream bike shop — nearly perfect!  Well worth the trip; come during clement weather and explore the area, too.  There are tourist traps a-plenty in Lancaster County, but also hidden gems just like this one.

Categories
Argyll Gear

Argyll Gets Ergons

(Can you say that fast?)  Thanks to a generous friend, whose Brompton is now sporting the Biokork version, Argyll and Dr. Diarist are enjoying new grips.

Except for that horrible moment when the original Brompton grips go under the knife, the procedure is fairly straightforward, and not otherwise emotionally traumatic.

eg-zk

Surgery and Brompton bicycles:  It just feels wrong. Nonetheless, the easiest way to remove the original Brompton foam is by cutting it.  Don’t score deeply; you don’t want a mark on the handlebars, even if you can’t see it.  Some standards should be observed.

eg-pf

Peeling the original foam slowly and evenly works pretty well.  Argyll’s left grip had hardly any adhesive beneath, but there was a broad band under the right one.

Getting the adhesive off the handlebar is the only challenging part of this little project.  The Ergons slip on pretty easily if most of the adhesive is removed.  I rubbed as much off as I could, then used household alcohol, sparingly applied with a microfiber rag, to soften the adhesive.

eg-sc

Then I went over the surface with a nylon kitchen scraper.  That got off most of the gunk; repeated applications of alcohol, and rubbing with the rag, did the rest.

There’s a 4mm bolt on the outer edge of the Ergon which will need loosening, but not by much, so that the grip can be slipped onto the handlebar.

Argyll’s grips are Ergon GP grips — probably the GP1 model.  These have to be cut down to fit on a Brompton M handlebar like Argyll’s.  You’ll want to measure carefully, but the cutting itself is easy to do with a utility knife, a mini-hacksaw or maybe a serrated kitchen knife.

ae-sgl

On Argyll, a 2014 Brompton, the edge goes right up against the brake lever retention ring.  That’s a nicer look than on Basil — on the 2012 models, the edge of the brake lever blocks an evenly cut Ergon. (The grips could be cut to fit around the lever, but that seems like an excessive pain to me, and wouldn’t allow for any future adjustments in angle..)

ae-ag

It won’t matter if the edges aren’t cut perfectly smoothly, unless you find that sort of thing completely maddening.  (In which case, take special care when cutting, and use a pipe cutter to mark the line you cut along.)  Once flush against the brake supports, the edge will not be particularly visible.

Getting the angle right may take some tinkering, and may vary quite a bit from cyclist to cyclist. Argyll’s grips tip just slightly downward (Argyll has an H-type stem, which is taller than the standard model):

aglv

But Basil’s are at a much steeper angle (Basil’s handlebars have been pulled slightly forward):

bsllv

It’s kind of amazing how the simplest projects become something else.  I had to remove Argyll’s Mirrycle mirror in order to install the Ergons.  That was a pain; the bolt was bent and had to be teased out of the handlebar.  Argyll had taken a fall in the past, and apparently there had been an internal injury we hadn’t noticed.

eg-mb

We bought a new mirror, and I replaced the bolt.  The crash wasn’t sufficient to break the glass on the original mirror, but the “protected” bolt bent anyway.  Curious, indeed! No matter; the issue was easily resolved. We like these mirrors very much; the Mirrcycle mountain bike mirror fits a Brompton perfectly, and can, if adjusted carefully, swing out of the way when the bicycle is folded.

Ergons come in various sizes; I’ve heard a rumor that there’s even a version that will fit Brompton M bars without requiring cutting.  When buying a model off the shelf at most bike shops, though, what you should know is that the paddle portion of the grip is sized — Argyll’s grips are size large, and Basil’s are small, reflecting the considerable difference in size between Dr. Diarist’s mitts and my own.  Choosing the right size will matter for optimal comfort.

Related, with a bit more detail about installation on Basil:

Basil Gets a Grip (or two)

Categories
Miscellaneous

We Have a Winner!

The “True Random Number Generator” at random.org has chosen a winner of the drawing for the Vincita Sightseer bag:

sightseer-randomThe winner is commenter number 33: Alexandria.  Congratulations to Alexandria, and thanks to everyone who entered — and to Vincita for providing such a great prize!

Categories
Miscellaneous

The Deadline Looms!

12/5/2014:  The giveaway is now closed. 

Thanks to all who entered; the winner will be announced within the next day or two as soon as feasible.

As frequent commenter Saul has noted, the clock is ticking: There are just over 24 hours left to enter the drawing for the Vincita Sightseer Transport bag.

st-bg

The drawing ends at midnight (USA EDT) on December 4, 2014!  Click here for details, and leave a comment if you’d like to be included!

Categories
Travel

A Brief Ride in New York State

After our Michigan trip, Basil and I spent a day at home and then headed for New York state.  The whole area is buried under snow now, but before Basil and I left we took a short ride on a new-to-us trail near Rochester, and got to experience autumn in yet another part of the country.

it-sr

Having, unusually, failed to get a picture of the trail designator, I’m not sure exactly which one we rode on.  We passed through Irondequoit, and for much of the trail, paralleled a highway, which may or may not be 404/104.  Tech failures of various kinds mean that I can’t confirm much of anything about this trip right now.  (No kudos to Garmin Connect, which hates my Linux computer.*)

it-hw

Parts of the route, therefore, were less scenic than they might have been, though there wasn’t much traffic in the afternoon, before the end of the work day.  This section of the trail system was built on an old rail bed; I don’t know if Monroe County cyclists use any part of it to commute to work.

it-ls

We had only a short window for our ride, but this is my favorite time of day.  Or perhaps I should say “my favorite light of day” since evening comes early in winter in northern geographies, and it’s appearance that matters to me, not the temporal designation: long shadows and oh, those golds!

it-eh

We turned around here, partly because I wasn’t sure where the trail went at this point, and because I had no lights on Basil.  I’m assuming these roadways are flooded with vehicles during commute hours, but they certainly look oddly unused in these photos.  Build a highway and they will come?

it-dc

Turning back meant a short course on a smaller street, and encountering this sign, the counterpoint to another regional one we saw in Northern Michigan.  There are streams, lakes and bays everywhere here; it’s nice to see that waterfowl are looked after.

it-bp

That’s the bike path, to the right — just a strip of nicely-done asphalt, making it an easy route for riders of all abilities.  The sign, set confusingly exactly between the highway and the path, says “NO PEDESTRIANS OR BICYCLES”, which, presumably, refers to the highway.  Otherwise, there would be no point to the path at all, right?

it-flr

We did pass a small glen, still bursting with greenery and flowers, and enjoyed the evergreens all along the highway.  Basil and I much prefer urban street-scapes or scenic views to riding along multi-lane roads, but any trail is OK with us, and much better than no trail at all.

*Dr. Diarist, a Computer Guy, is on the case, but not until he’s sorted out a  massive re-organization of the essential equipment that makes our technical lives run.  Shoemaker’s children and all that.  It’s all good; gotta have an infrastructure!

Vincita Sightseer Giveaway!

Remember:  the Sightseer Giveaway is still on until midnight (USA EDT) December 4, 2014!  Click here for details, and leave a comment if you’d like to be in the drawing.